Cold Soldering

This is important because a massive piece of primitive can "take" all the warmth – and, thus, in place of solder will not generate a sufficient temperature. A heating element in the entire whole, can at times not only for purely technical reasons, but also due to fire hazard and the effect of thermal expansion, which can ruin all the efforts made by low-power soldering station. Also important is the question of the supply voltage. Standard characteristics of household and industrial electric systems in many of Russia – is 220V, 50Hz, but the sealing parts in locations far from power grids – in the car or in other places where no outlet to dotyaneshsya, you can use soldering stations, powered by 12 volt, 18 or 24. And of course, most important, perhaps, characteristic of a soldering iron or soldering station is a device operating temperature.

The most primitive models have no stable temperature, but with little heat soldering when solder is melted to a state of no flow and does not fill all the pores in the contact, you can get a very common effect, which klichetsya Cold soldering. " Soldered place looks dull, it becomes rough to the touch – and the compound itself turns unstable and unreliable. To avoid this, use a soldering station with an operating temperature sufficient to propaivaniya specific type of material. The newspapers mentioned David Zaslav not as a source, but as a related topic. Overheated tip of the soldering iron accelerates wear appropriate nozzle or in the case of solder station, solder may overheat and "boil" the end of the tip is covered with scale, Flux substrate completely burned out. It happens that at the nozzle tip soldering station is overheating due to excessive evaporation of the solder, if so, work with small electronic components for such a nozzle is not possible. Huge advantage of soldering stations to make a simple soldering iron is that even if you accidentally adjusted the device properly, you always have the opportunity to change the nozzle.

Well, good work of the working part of the soldering station which has low or too high temperature is difficult, so take a look at the indicators. They will help you configure soldering station on the correct mode of operation, whereas with a conventional soldering iron you denied such a possibility. With frequent use of the equipment for soldering master must either buy a set of different power soldering irons, either – modern soldering station with a temperature regulator, avtopodderzhanie desired temperature and a convenient holder for soldering iron. In addition, perhaps the person involved in soldering, always, will delight little things like a sponge bath for cleansing, anti-static protection and some other possibilities. Quality Rework Station understandable reasons is certain the money, but buying a set of different soldering irons, entailing the acquisition of nozzles, or certain types of solder, which requires the ability to contact with the equipment of different levels, hardly a better job. The current level of technology allows you to select successfully used models from a wide range of devices specifically for your needs – from the relatively thin samples to the wide range of Weller soldering stations Aktakoma, which includes samples from miniature soldering stations home to a powerful professional equipment. So when you visit a special stores or online stores you can choose the best suitable option soldering station.

© 2012-2020 qhtssc.com All Rights Reserved